安装方式对浮法玻璃热破裂行为影响*

doi:10.16265/j.cnki.issn 1003-3033.2021.07.009

中国安全科学学报 ›› 2021, Vol. 31 ›› Issue (7): 63-69.doi: 10.16265/j.cnki.issn 1003-3033.2021.07.009

安装方式对浮法玻璃热破裂行为影响^*

张嬿妮^1,2 教授, 温心宇¹, 冯志超¹, 刘春辉¹, 侯云超¹

1 西安科技大学安全科学与工程学院,陕西西安 710054;
2 国土资源部煤炭资源勘查与综合利用重点实验室,陕西西安 710021

收稿日期:2021-04-17 修回日期:2021-06-14 出版日期:2021-07-28 发布日期:2022-01-28
作者简介:张嬿妮 (1978—),女,山西阳城人,博士,教授,主要从事城市火灾防治、建筑火灾防护等方面的研究。E-mail:zyn2099@xust.edu.cn。
基金资助:
国家自然科学基金资助(51674191)。

Study on influence of installation method on thermal cracking behavior of float glass

ZHANG Yanni^1,2, WEN Xinyu¹, FENG Zhichao¹, LIU Chunhui¹, HOU Yunchao¹

1 College of Safety Science and Engineering, Xi'an University of Science and Technology, Xi'an Shaanxi 710054, China;
2 Key Laboratory of Coal Resources Exploration and Comprehensive Utilization, Ministry of Land and Resources, Xi'an Shaanxi 710021, China

Received:2021-04-17 Revised:2021-06-14 Online:2021-07-28 Published:2022-01-28

摘要/Abstract

摘要： 为研究浮法玻璃在建筑火灾发展过程中,不同安装方式对其破裂行为的影响,以尺寸为600 mm×600 mm×6 mm的浮法玻璃为研究对象,分别采用点支撑、框支撑(4边遮蔽、左右遮蔽、上下遮蔽)和无遮蔽5种安装方式,分析不同安装方式下的浮法玻璃在热载荷作用下的破裂行为,得到浮法玻璃的首次破裂时间、玻璃表面温度及空气温度、裂纹起裂位置和裂纹扩展行为等特征参数。研究结果表明:在热载荷作用下,选用无遮蔽安装方式的浮法玻璃在试验中未发生破裂,其防火性能最好;而选用点支撑安装方式的浮法玻璃首次破裂时间最短,其裂纹以直裂纹为主,且起裂位置发生在玻璃的支撑点处,其防火性能最差。

关键词: 安装方式, 浮法玻璃, 热破裂行为, 热载荷, 裂纹扩展

Abstract: In order to study influence of different installation methods on cracking behavior of float glass in the process of building fire development. Taking float glass with size of 600 mm×600 mm×6 mm as research object. Five installation modes were adopted, such as point support, frame support (4 side shielding, left and right shielding, upper and lower shielding) and no shielding, crack behavior of float glass under different installation modes under thermal load was analyzed, characteristic parameters such as the first crack time, glass surface temperature and air temperature, crack initiation position and crack propagation behavior of float glass were obtained. The result shows that float glass with non-masking installation mode does not crack under thermal loads, and its fireproof performance is the best. The first crack time of float glass installed with point support is the shortest, cracks are mainly straight cracks, and crack initiation position occurs at the support point of glass, and its fire resistance is the worst.

Key words: installation method, float glass, thermal crack behavior, thermal load, crack propagation

中图分类号:

X932

张嬿妮, 温心宇, 冯志超, 刘春辉, 侯云超. 安装方式对浮法玻璃热破裂行为影响^*[J]. 中国安全科学学报, 2021, 31(7): 63-69.

ZHANG Yanni, WEN Xinyu, FENG Zhichao, LIU Chunhui, HOU Yunchao. Study on influence of installation method on thermal cracking behavior of float glass[J]. China Safety Science Journal, 2021, 31(7): 63-69.

参考文献

[1] 辛天兵, 高占彬. 玻璃幕墙建筑火灾特点及消防设计分析[J]. 科技展望, 2016, 26(14):49.
[2] 雷晶晶, 王妍, 周汝, 等. 无风条件下火灾时建筑外立面烟羽流形态特征研究[J]. 中国安全科学学报, 2018, 28(12):52-57.
LEI Jingjing, WANG Yan, ZHOU Ru, et al. Study on form of smoke plume at façade of building in fire under windless condition[J]. China Safety Science Journal, 2018, 28(12):52-57.
[3] 周扬, 夏登友, 高平. 城市商业综合体建筑火灾事故演变路径分析[J]. 中国安全科学学报, 2018, 28(2):170-174.
ZHOU Yang, XIA Dengyou, GAO Ping. Analysis of evolution path of urban commercial complex fire accident[J]. China Safety Science Journal, 2018, 28(2):170-174.
[4] 张金菊, 王丽琼. 防爆膜对中空玻璃防护效果的试验研究[J]. 中国安全科学学报, 2019, 29(10):78-83.
ZHANG Jinju, WANG Liqiong. Protection effects of explosion-proof film on insulating glass[J]. China Safety Science Journal, 2019, 29(10):78-83.
[5] 张明空, 胡小兵, 王静爱. 考虑火灾动态扩散过程的高层建筑疏散路径研究[J]. 中国安全科学学报, 2019, 29(3):32-38.
ZHANG Mingkong, HU Xiaobing, WANG Jing'ai. Research on evacuation route form high-rise building under real effect of fire spread[J]. China Safety Science Journal, 2019, 29(3):32-38.
[6] EMMONS H W. The needed fire science [M]. Cambridge, Massachusetts: Fire Safety Science-Proceedings of the First International Symposium, 1986:33-53.
[7] SKELLY M J, ROBY R J, BEYLER C L. An experimental investigation of glass breakage in compartment fires [J]. Journal of Fire Protection Engineering, 1991, 3(1):25-34.
[8] 张庆文. 受限空间火灾环境下玻璃破裂行为研究[D]. 合肥:中国科学技术大学, 2006.
ZHANG Qingwen, Research on glass rupture behavior under fire environment in confined space[D]. Hefei:University of Science and Technology of China, 2006.
[9] 苏燕飞, 王青松, 赵寒, 等. 中空玻璃受热破裂行为规律研究[J]. 火灾科学, 2015, 24(1):1-8.
SU Yanfei, WANG Qingsong, ZHAO Han, et al. The fracture behavior of hollow glass under heating condition[J]. Fire Safety Science, 2015, 24(1):1-8.
[10] 王禹. 火灾下玻璃幕墙破裂行为的实验和数值模拟研究[D]. 合肥:中国科学技术大学, 2016.
WANG Yu. Experimental and numerical study of glass façade breakage behavior under fire conditions[D]. Hefei:University of Science and Technology of China, 2016.
[11] WANG Yu, XIE Qimiao, ZHANG Yi, et al. Sensitivity analysis of influencing factors on glass façade breakage in fire [J]. Fire Safety Journal, 2018, 98:38-47.
[12] 王禹, 王青松, 黄柯, 等. 点式安装玻璃幕墙在火灾中的破裂行为[J]. 燃烧科学与技术, 2015, 21(3):241-247.
WANG Yu, WANG Qingsong, HUANG Ke, et al. Breakage behavior of point-supported glass facades in fire[J]. Journal of Combustion Science and Technology, 2015, 21(3):241-247.
[13] LU Wei, DUAN Qiangling, CHEN Haodong, et al. Thermal response and resistance optimization of various types of point-supported glass facades [J]. Construction and Building Materials, 2019, 224:610-621.
[14] 金静, 阳圣涛, 殷佳星, 等. 火场中玻璃裂纹特征与破坏条件的关联性[J]. 消防科学与技术, 2020, 39(1):135-138.
JIN Jing, YANG Shengtao, YIN Jiaxing, et al. Research on relationship of crack characteristics and failure condition of glass in fire scene[J]. Fire Science and Technology, 2020, 39(1):135-138.
[15] 李慧, 蒋军成, 王若菌. 池火灾热辐射的数值研究[J]. 中国安全科学学报, 2005,15(10):7-10.
LI Hui, JIANG Juncheng, WANG Ruojun. Modeling and numerical study of pool fire heat radiation[J]. China Safety Science Journal, 2005,15 (10):7-10.
[16] 冯志超. 浮法玻璃热破裂行为研究[D].西安:西安科技大学,2020.
FENG Zhichao. Study on the fracture behavior of float glass[D]. Xi'an:Xi'an University of Science and Technology, 2020.

安装方式对浮法玻璃热破裂行为影响^*

Study on influence of installation method on thermal cracking behavior of float glass

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 8

编辑推荐

Metrics

本文评价

[1]	朱豪豪, 郭海林, ZHUMAKELDI A. 外力作用下管道内表面缺陷处裂纹扩展研究[J]. 中国安全科学学报, 2021, 31(3): 66-72.
[2]	李坤元, 刘佳亮. 磨料水射流多维参数对混凝土致裂性能影响特征[J]. 中国安全科学学报, 2019, 29(10): 110-116.
[3]	杨艺，金龙哲，栗婧，李婷婷. 救生舱高温环境的传热研究[J]. 中国安全科学学报, 2012, 22(12): 138-.
[4]	范小宁，徐格宁，杨瑞刚. 基于损伤-断裂力学理论的起重机疲劳寿命估算方法[J]. 中国安全科学学报, 2011, 21(9): 58-.
[5]	吴晓，罗薇，刘璐，黄园园. 在役桥(门)式起重机金属结构疲劳寿命预测分析[J]. 中国安全科学学报, 2010, 20(2): 95-.
[6]	刘青峰，任尊松，谢基龙，缪龙秀. 提速货车钩尾框安全使用寿命的估算方法[J]. 中国安全科学学报, 2003, 13(8): 56-.
[7]	陈艳华，石志飞，孟凡胜. 钢筋与混凝土界面的腐蚀疲劳[J]. 中国安全科学学报, 2003, 13(3): 42-.
[8]	刘志明，徐倩，缪龙秀. B级钢侧架圆角细节耐久性力学模型研究[J]. 中国安全科学学报, 2003, 13(1): 75-.